First picture PreviousLatest Entry Next Last picture
Click to Enlarge

I forgot to take a pic of the other gas cap flange installation. Basically, you cut the foam away as shown in the previous picture. You then sand the inner skin clean to allow a good bond. The flange goes to the drill press for a dozen or so 1/8" holes, and it then gets scuffed. Wet out the hole with microglass, smoosh the flange in, backfill the hole with micro, clean up the edges, and glass down with two BID. Soory, no pic of the glass work. I will try to get a shot of the entire finished upper strake skin before closing the strake out.

8/30/2008   Picture 78

** Click picture for large version